Your browser does not seem to support JavaScript. As a result, your viewing experience will be diminished, and you have been placed in read-only mode.
Please download a browser that supports JavaScript, or enable it if it's disabled (i.e. NoScript).
undefined 11 Feb 2018, 18:44
I believe it should be subtract to increase gap between nozzle and bed
and add to decrease gap between nozzle and bed
undefined 11 Feb 2018, 17:13
Thanks DC, I found my problem. I had the HomeZ and HomeAll configured wrong for the Z axis
undefined 2 Oct 2016, 10:42
The amount of filament used since the start of the print is displayed on the Print Status page, above the right hand end of the progress bar.
undefined 16 Sept 2016, 23:29
Perfect, working fine thanks
undefined 12 Sept 2016, 13:04
Yes we will contact you to arrange a swap of controller and cable.
undefined 5 Sept 2016, 05:54
Yes, but I never bothered to check if it fixed it, I just started using firefox since I have all 3 installed.
