hopefully my red head sacrifice takes hold and the gods will be pleased with me. we'll find out tomorrow, I don't wish to pursue any 3d printing tonight.

@dc42:

@sLpFhaWK:

I can't PID tune my Aero either. I don't particularly care for how quick RRF cancels the tune just because it goes over temp by .1 degree. Usually in tuning it goes over I thought to know what value's to change to not overshoot the temp by too much.

It's changed in version 1.18, you set a target temperature and normally leave the PWM at 1.0.

Okie. I will give that a shot later, I am currently printing something to test everything. For now everything seems to be working but I have the heated bed on Bang Bang and it over shoots the temp by like 9 degrees. No idea why, my other Kossel doesn't do that.

I can't PID tune my Aero either. I don't particularly care for how quick RRF cancels the tune just because it goes over temp by .1 degree. Usually in tuning it goes over I thought to know what value's to change to not overshoot the temp by too much.

This is also a 24v Aero, I don't know if the crappy meter I have is good enough to test the resistance and I Will check that tomorrow but my crimps are all solid on both ends.

I have a 713 maker mount for my e3d on my v2 max, but I'm using a printed effector on my kossel, I'd really like to use that mount on the kossel, but I'm not sure if he makes parts for other deltas.

Okay, I saw the issue in another thread with the github bug while downloading firmware.. that was the issue for me, i clicked view raw and it downloaded the full file now i'l back in business!

I had an old 0.6 board sitting on 1.15d. I tried updating it over the web to stable 1.17e but after it said it was updating it hung and no longer connected via the web.

I bossac'd it and put numerous versions on there to try and get it to work, but alas it hasn't recovered.

I remember not seeing an iap4e.bin file but I don't know where to get it, I put the iap.bin from the beta 1.18 release on the github into the sys folder on the memory card.

I don't know what more to do.

I think I just found my answer,

If using JohnSL's trinket board: Connect its Vcc, Output and Ground pins to 3V3, STP and GND respectively on the E0 endstop connector, and select mode 4. Alternatively, connect them to 3.3V, IN and GND on the Z-probe connector and select mode 5.

Thanks, but FSR's aren't a proximity based sensor, and I had it wired up before I just forget how i had it. I didn't know I could wire the 12v to those pins though, so thats a bonus.

I'm going to be putting is this old Duet into a Mini Kossel and replacing the smoothieboard.

It's been a while since I used it, but I cannot find a pinout for the board that isn't showing a 0.8.5 board, even on the wiki.

I have XYZ E0 heated bed, FSR and PArt fan.

I think the HE Fan just gets wired to 12v so it's always on, which isn't an issue. Does the part fan get wired to Fan0? Where does the FSR connection go, next to E0 using the E1 set of pins?

Thanks!

So is baby stepping similar to the first layer adjustment on the Prusa I3 MK2? Like you print the first layer and you can adjust it with the knob on the LCD, but instead use Macro's? If so this is a fantastic feature.. I really hope it is