Topics created by steevebecker

It is a ZProbe we made ourself.
An electromagnet takes out a rod, on this rod is fixed a blade which hides or not a standard optical endstop.
b8211d45-db7b-42ee-8fd3-88c0541a454a-image.png

The 5V regulator on an expansion board is rated at 1A total. The MCU takes about 0.1A.

Note, large servos dump power into the +5V rail when they decelerate. The internal 5V rail on the expansion board (and the Duet 3 main board) are protected against over-voltage, but could damage anything else that you connect to the 5V outputs.

Perfect, it works, the firmware is uploaded...
Thanks for your fast reply.

Erased the firmware Uploaded RRF3 beta12 with Bossa

Perfect, everything works like before...

Thank you

@dc42 said in DUET 3 + RRF3 : update firmware version from 3 alpha to 3 beta11:

DSF from the package server using "sudo apt update" and

Solved ! THANKS update the DSF was the solution.

Now :
Board: Duet 3 version v0.6 (MB6HC)
DSF Version: 1.1.0.5
Firmware: RepRapFirmware for Duet 3 v0.6 3.0beta11 (2019-10-21b1)

@steevebecker not yet

The bed is not a tool. The default bed heater is heater 0 and can be changed using the M140 command, same as in previous versions of RRF.

@steevebecker said in DUET 3 + RRF3 : F1 not working:

my config: Duet 3 6HC with RRF3 + exp 3HC

Firmwate version?

@steevebecker said in DUET 3 + RRF3 : monitor Temperature wihtout heater or tool:

Hi,
my config: Duet 3 6HC with RRF3 + exp 3HC

is it possible to monitor on DWC a thermistor temperature without defining a Heater and a Tool ?
how ?

Thanks

Yes, you declare a sensor using M308. If you give it a name, it will be visible in the Extras tab of DWC.