Duet3D Logo Duet3D
    • Tags
    • Documentation
    • Order
    • Register
    • Login
    1. Home
    2. tcj
    3. Topics
    • Profile
    • Following 0
    • Followers 0
    • Topics 5
    • Posts 28
    • Best 5
    • Controversial 0
    • Groups 0

    Topics created by tcj

    • tcjundefined

      Faulty Smart Effector

      Smart effector for delta printers
      • • • tcj
      18
      0
      Votes
      18
      Posts
      791
      Views

      Phaedruxundefined

      @Lightpath said in Faulty Smart Effector:

      @Veti said in Faulty Smart Effector:

      C"zprobe.in+zprobe.mod"

      This should be in the documentation.

      Consider it done.

    • tcjundefined

      FYSETC Mini 12864 @ Maestro - HowTo?

      Duet Hardware and wiring
      • • • tcj
      5
      0
      Votes
      5
      Posts
      305
      Views

      tcjundefined

      @dc42 Take your time.

    • tcjundefined

      Maestro and other types of 12864 LCD?

      Duet Hardware and wiring
      • maestro 12864 lcd controller • • tcj
      7
      0
      Votes
      7
      Posts
      638
      Views

      dc42undefined

      @tcj said in Maestro and other types of 12864 LCD?:

      Thank you for the information.

      Do you know less "bulky" LCDs than the typical reprapdiscount type?

      I'm sorry, I am not familiar with all the different 12864 displays on the market. We chose to support the RepRapDiscount because it has been widely cloned and is in widespread use.

      When we revise the design of the Maestro, we'll look at providing another level-shifted output so we can support these other types of 12864 display.

    • tcjundefined

      Maestro: Turning a 12864 on/off?

      Duet Hardware and wiring
      • • • tcj
      7
      0
      Votes
      7
      Posts
      352
      Views

      dc42undefined

      @tcj said in Maestro: Turning a 12864 on/off?:

      Just realized, that I don't have any free heater or fan output. Could I use EXP0 instead?

      You would need to use a small mosfet or NPN transistor + resistor to control the backlight from an expansion pin.

    • tcjundefined

      Duet & new and stock Anycubic Kossel Linear Plus - config files?

      Duet Hardware and wiring
      • • • tcj
      5
      0
      Votes
      5
      Posts
      1.5k
      Views

      Juiceundefined

      @tcj
      I have a working config file for the AKL+ but you'll still need to do an auto calibration to get the particulars for your build. When i get home tonight i'll upload it.

      Oops, i just realized that mine isn't completely stock anymore, i have an e3d v6 on it and a different effector. If you'd still like to try, here it is.
      0_1531006429583_config.g
      You'll need to edit it a bit before you use it, specifically the network settings. After that, your z probe offset if you use the one supplied, will need to be set. Oh, and remove the ; from the M501 command under "Calibration" so that the config override can be used while you calibrate. Oh, and make sure you do a PID auto calibrate to get some values for your hotend heater before you start printing.