I have a new RatRig VCore 3, Duet 3 with an SBC and RepRap firmware. I'm struggling with the configuration, probably because I'm not fluent in gcode, but I've got one particular issue of concern. How do I enter the parameters needed for a Slice Mosquito heater and thermistor? The Mosquito comes with a warning that you must configure for a 100k thermistor and if you don’t it can be a fire hazard. So I’d really like to know how to configure this as I can’t find it anywhere. The downloadable config.g is setup for an E3D-V6, so I guess it’s incorrect, but I don't see the settings. Thanks for your help in advance.