Bltouch setup need help

Phaedrux

@Elvis0z said in Bltouch setup need help:

Hey guys need help to set this up its a v1.0 bltouch.

Is this a version with the trace to cut or does it come with the resistor? It's been a long time since I've seen anyone with a V1, so I'm wondering if it matters in this case. If it's a new Duet 1.04 it can't be hurt by 5v, but perhaps there is something in the BLtouch that will not trigger. If removing the ^ and checking your white wire is fruitless, maybe look into the trace/resistor

Elvis0z

No I replaced it with a v3.1 that I had

Elvis0z

If I send command M401 and M402 it triggers

Phaedrux

You mean it deploys and retracts?

When you send G30 does the pin deploy?

Elvis0z

I get this error when sending G30

G30

Error: G30: Insufficient axes homed for bed probing

Elvis0z

@Phaedrux

Yep deploys and retracts that is for the M401 M402 commands

Phaedrux

Ok home X and Y first, move the print head to the center and then send G30. Does the pin deploy? Does the Z axis move? If you touch the pin does the Z axis stop?

Elvis0z

@Elvis0z said in Bltouch setup need help:

Error: G30: Insufficient axes homed for bed probing

Yep deployed and red light went out and got the error

Error: G30: Insufficient axes homed for bed probing

JoergS5

@Elvis0z please remove
M307 H3 A-1 C-1 D-1
this not valid in RRF3 any more.

Edit: this is the source: https://duet3d.dozuki.com/Wiki/RepRapFirmware_3_overview#Section_M307

Elvis0z

@JoergS5
Yep removed

Phaedrux

@Elvis0z said in Bltouch setup need help:

Error: G30: Insufficient axes homed for bed probing

Just to make sure, the files you are editing are in the /sys folder, right?

Elvis0z

@Phaedrux

Yep

Phaedrux

Can you upload the actual files to your post? config.g homeall.g homex.g homey.g homez.g deployprobe.g retractprobe.g

And maybe a photo of your wiring?

Elvis0z

Not sure what you mean "Actual files" or how to do it not copy paste?

Phaedrux

In the /sys folder select the files and then right click and download. Then drag the files onto the post text box in the forum to upload.

Elvis0z

config.g
deployprobe.g
homeall.g
homex.g
homey.g
homez.g
retractprobe.g

Elvis0z

Thank you for all the help. I have to go out for a while will be back
Cheers

Phaedrux

Can you send M98 P"config.g" in the gcode console and report the results?

Elvis0z

@Phaedrux yep will do soon as I'm back home

JoergS5

I am not sure whether it's a problem that retractprobe.g doesn't have a CRLF at the last line.