@bearer Yes I use octoprint only to print in connected mode with palette2, on my octoprint I have duet and palette connected

@bearer
On duet I have 2.0.7, and on palette the latest

I tried the command but it disconnect all ports and i'm not able to see devices.

Hi
I connected today my duet to my octoprint to use my Palette in connected mode but if the printer is off and the raspberry is on I see the bltouch on and the paneldue blinking, why?
How can I fix this problem?

@deckingman

it's a direct, I have less than 10cm of bowden tube between bmg and hotend

Hi

As you can see in the picture I have problemswith my direct BMG corexy, these are my config:

Hi

I wired and configured on a duet wifi a new bltouch original, I'm able to do self test, I'm able to extend and retract it but I read this:

If all is well the web interface should report a value of ”0” in the Z probe column when the pin is extended. You can then lightly touch the extended probe pin to check that the pin retracts, the value in the Z probe Column should change to “1000”

My bltouch value 0 is when is retract and 1000 if I try to touch.

I'm trying to do M30 to make first configuration, the bltouch pin extend but when touch the bed it start blinking.

My conf is:

; Axis Limits
M208 X0 Y0 Z0 S1 ; set axis minima
M208 X300 Y300 Z350 S0 ; set axis maxima

; Endstops
;M574 X1 Y1 Z2 S1 ; set active high and disabled endstops
M574 X1 Y2 S0 ; set active high and disabled endstops
M574 Z1 S2 ; set endstops controlled by probe

; Z-Probe
M307 H3 A-1 C-1 D-1 ; disable heater on PWM channel for BLTouch
M558 P9 H5 F100 T2000 ; set Z probe type to bltouch and the dive height + speeds
G31 X0 Y-36 Z0.3 P25 ; set Z probe trigger value, offset and trigger height
M557 X60:215 Y60:215 S40 ; define mesh grid

Thanks

@bot how?

Hi
I calculate my hz but where I've to put the m593 command inside the conf.g?

@deckingman hi
Today I received new stepper motors for another printer, I tried to install them:

Technical info:
-Manufacturer: LDO
-Model: LDO-42STH47
-Holding Torque: 5.5 kg/cm - 76oz-in
-Shaft: 5mm
-Voltage rating: 3.1V
-Stepping angle:1.8 degrees
-Current rating: 2.5A/Phase
-Connector type: JST PH-6

So I see max current 2.5, what's the right current? Right now with same configuration of 800 print better than other motors but I hear a little noise and vibration.