Topics created by Dav

@Dav said in Duet Wifi + Raspberry Octoprint Power Problem:

Yes I use octoprint only to print in connected mode with palette2

You might find thats not immediately obvious to everyone how its all connected; maybe adding a diagram or picture will illicit more input from the rest of the clever people here.

the max retraction speed for the Dyze is 25mm/s , but i will try the other settings....i can always go higher than 25 but am sure will be clogging time

What Duet are you using? How do you have it wired up? What firmware?

When the BLTouch triggers the 1000 in the probe status may only show very very briefly or not at all. It's not a good way to test if the BLTouch is working.

Check this instead https://duet3d.dozuki.com/Wiki/Test_and_calibrate_the_Z_probe

@Dav Look at the rated current section in the Duet documentation here https://duet3d.dozuki.com/Wiki/Choosing_and_connecting_stepper_motors

@Dav said in Help Core XY:

I was using a mks board with tmc2208 and my stepper were very quiet, no vibration, now with duet i hear a little noise that cause a little vibration, can be this the problem?

What else changed on the printer at the same time?

@Phaedrux found the problem, for si of all connected x motor on x connector and y motor on y connector, I changed the y direction, now if I click - is coming to the front like you ask me to check.
I think everything working now.

yes it makes sense

are you walking about something like this?
https://duet3d.dozuki.com/Wiki/Bed_levelling_using_multiple_independent_Z_motors