@agz90 install firmware 3.6.0 Release Candidate 1

@agz90 

@Phaedrux said in RRF to Duet3 6HC:

How are you checking it?
What error does it report?
Are you following these steps to flash the firmware?

Yes, I followed all the steps exactly as described. Checked with Bossa verify. My problem is that I thought I could install Clipper on the board, apparently I deleted the boot file and now it doesn't work. I don't know how to restore the rep rap on the board.

@agz90 said in RRF to Duet3 6HC:

Hello, I have a problem installing the rap rap on the board. I load the latest rap rap with Bossa, it saves it, but when I check it, it gives me an error and the board doesn't start.

Problem installation firmware to Duet3 6HC v 1.02

Hi. My Duet3 6HC rev.1.02 after start print after a few printed layers it stops communicating with RRF36, more precisely it stops extruding thread and moving Z up, with baby steps I try to move but the motors just buzz and don't move. Could there be a problem with the board? I have a spare one but it's a clone version 1.01, I'll try it.

@edsped
Hello, I found the problem, not every fan is suitable for Can.
I tried several models and found the right one, now I'm satisfied.
Thanks for the help though.

@gloomyandy
Thanks

@agz90 said in Fly-RRF-36 RP2040 not work second fan:

@agz90
I tried swapping them but then none of the fans start. On the board, the diode lights up, but no fan moves.

and where to set the fans with M563

@agz90
I tried swapping them but then none of the fans start. On the board, the diode lights up, but no fan moves.