@zapta Hi Zapta, thanks for the macro, I will try to place it.
For the choice of the printer: I am an ortho-prosthetist and I do humanitarian missions in Africa. So I tried several printers. I work with soft materials to make feet and hands and some sockets. So I have to have an extruder with a direct drive. I can't have a platen that moves in XY and I need to have a minimum height of 60cm to print the thighs. I have a CR10V3 to make the feet.

Hi @Phaedrux,
The hotend STD6 will be used with Orbiter v2.
Duet 2 WiFi Server Version: 1.23
Here is the STD6 link:

• Built in PT1000 RTD sensor
  Cylindrical heater 24V 144W.
  Notice that it's 144W.
  I'm also adding 2 fans for the nozzle: 24v - 0.18A
  Thanks.

@Roberto
Oops, I forgot to tell you which 3D printer.
It's a RailCore XY 300ZLT

Hello everyone, I would like to place this hot-end trianglelab STD6 ceramic heating core: Heating voltage: 24V
Heating power: 125W @24℃.
Does anyone have experience with this equipment?
If I plug it in as is, isn't there a risk of burning everything?
Thanks for your help.

@phaedrux Ok! I will check the calibration of the BLTouch.
Thanks for the info.

@phaedrux Hello,
I did some more tests.When I do the homes, I can't get it to go lower than -0.5. But with the baby stepping, I can get the tray up to the nozzel.
I go into the config and make the change.
Then when I do the homes, the plate goes back too low and again from -0.5 I can't make it go up.
Here are the settings.
I think that it is the BL-Touch that is out of adjustment.
How can I recalibrate the BL-Touch?
Thanks for the help.

SYSTEME.docx

@roberto he writes:
Error: Z probe already triggered at start of probing move Error: G0/G1 : insufficient axes homed

@oliof I move the Z axis with the dashboard move command.
But, at Z-0.5mm, the motors don't respond anymore?
And the plate does not go up anymore. When I manually put the bed against the head, once I do the Z home, the bed goes back too far from the head. And even when I lower manually the tray voluntarily too much. I make the Zhome and again it comes to put itself with the same spacing with the head

@roberto Do I have to raise the plate manually?

@oliof Once I get to -0.5, the engines don't run anymore when I ask it to go to -1

@roberto I can't get the bed up near the nozzel