Topics created by Roberto

@Roberto a 144W 24V heater will draw 144/24 = 6A. That's just within the limits of the Duet 2. I recommend that you use ferrules on the heater wires when connecting them to the terminal blocks. Also re-check the tightness of the heater terminal block screws every few hours, until you are confident that they are not loosening (which can happen because of thermal creep).

@phaedrux Ok! I will check the calibration of the BLTouch.
Thanks for the info.

@roberto With a 2mm nozzle, do you use 3mm filament?
Do you have a hotend with a surround heater-cartridge, like the new E3D rapid change revo?
I could imagine, with a classic heaterblock (even a Volcano) the filament will not melt evenly.

@zapta Thank you, I'll give it a try.

@zapta Hello Zapta,
the prostheses are completely personalized.
There are two ways to make the sockets. The technician who is in Africa, take the scan of the patient's stump or with the plaster, he makes the mold of the child's leg, he makes the corrections and then sends it to me by internet. I do the modeling with the software and I set the G-code and I send it to the technician who will print it at home.

@t3p3tony
Thanks, I will try.