Topics created by benha

@dc42 So I just added the command M570 H3 P10 T20 for my chamber heater and now I get a lot of random heater faults during normal operation that worked pretty good before.
The weird thing is that I now even get heater faults when the current temperature is only a few degrees away - shouldn't there be any fault with +/- 20 °C now?
The heater is freshly tuned.
error.png

Can you test the probe trigger height at a few different points on the bed and see if it's consistent?

https://docs.duet3d.com/en/User_manual/Connecting_hardware/Z_probe_testing#calibrate-the-z-probe-trigger-height

Heh, I guess so. Weird. I thought I updated everything correctly when I set this up a week ago, but I guess the DWC is still ancient.

Stand by...

Fair enough...

After reading this:
Screen Shot 2020-08-06 at 3.00.27 PM.png

And looking at this:
Screen Shot 2020-08-06 at 2.59.54 PM.png

I had to figure out where to connect the wires.

For the positive leg, V_OULCn clearly maps to the V_OUTLC1 pins in the picture. That said there's a typo. The doc should read V_OUTLCn not V_OULCn.

I was confused about the ground leg. The text "OUT_n_NEG pin (-ve)" from the doc doesn't map to specific text in the drawing. The closest looking one is OUT 6 GND so I went with that. If the doc read that it should go to outn it would be clearer.

Think of unfiltered as a more direct, immediate, and sensitive.