Topics created by CSLTM

@dc42 @deckingman @droftarts

Thanks for the suggestions all! I've updated the boards to 3.3 and will try @deckingman 's solutions tomorrow and let you know!

Many thanks,

Tom

@csltm said in Issue with thermostatic fans on Toolchanger with Toolboards:

@fcwilt Hi Frederick,

You were spot on! Hadn't realised that RRF3 changed the way that H was utilised.

Works a treat now.

Many thanks,

Tom

Glad I could help.

Frederick

@csltm The 3.3 firmware is here https://github.com/Duet3D/RepRapFirmware/releases/download/3.3/Duet3Firmware_EXP3HC.bin

@csltm upload the correct file and send M997 Bx where X is the toolboard CAN number

Hi @CSLTM
I fell in the same trap lately > M584 should come very early in config.g
I'd put it before M669 to be sure.
The configuration tool will be adapted soon.

@jay_s_uk Thanks for your reply.

The switch won't be moving - its within the limits of the gantry movement but to the left of the print surface. It is just a standard microswitch with a metal actuator.

My plan was to have the machine pick up tool0, have the bed rise to hit the switch three times, make an average of the offset and then put the tool back and pick tool1 up and do the same.

Ideally then each tool would have a -z offset from 0 that I can put into the config.g so that the Z heights are accurate.

Thanks for the link, I'll check that out.

Cheers,