Topics created by d0minik96

@d0minik96 said in 3D Touch affects Heater 1 Sensor:

Would it be possible to share the ground in the Duet board aswell?

Only if you accept less accurate temperature readings at high temperatures.

You can share the positive supply to the heater and fan(s) if they all use the same voltage.

@zapta said in Changing the behaviour of "cancel print":

Does duet invoke stop.g when a print is canceled?

RRF runs cancel.g in preference to stop.g when a print is cancelled .

@argo
i print from highest to lowest. Ty for the commands 🙂

I have also checked the converter with my drone DJI Mini, and it worked quite well.

S0 is no longer used in RRF3. You use S1 and must invert the signal with !

ok thank you guys! I ordered the chip and luckly i'm a working student on my University and there is someone, who helps me to replace the chip. But for the time beeing i just connect my powerbank via the usb cable 😄

This is coreXZ. It's very different. It's basically a coreXY rotated 90 degrees on it's end.

https://reprap.org/forum/read.php?2,377858

@engikeneer Good eye!