Your browser does not seem to support JavaScript. As a result, your viewing experience will be diminished, and you have been placed in read-only mode.
Please download a browser that supports JavaScript, or enable it if it's disabled (i.e. NoScript).
undefined
Ok thank you 🙂 I guess that is just a little confusing from looking at the wiring diagram, but I guess it just depends on how you interpret that they are paired. 0_1532564513167_D79A2D5B-B444-432D-AD78-4D26F53AC875.png
You need to perform delta calibration. See https://duet3d.dozuki.com/Wiki/Calibrating_a_delta_printer#Section_Setting_up_your_initial_delta_parameters and https://duet3d.dozuki.com/Wiki/Calibrating_a_delta_printer#Section_Auto_calibration.
@t3p3tony Yes, I think it is fine now. Thank you.
@mmoram https://duet3d.dozuki.com/Wiki/Connecting_a_Z_probe#Section_If_you_do_have_a_DueX2_or_DueX5_expansion_board
