Topics created by esobreiro

I revert the firmware from 3.2 to 2.05.1 and everything is working fine. Thank you!

I revert the firmware to 2.05.1 (from 3.2) and its all working now! Thank you

@esobreiro you probably can but its best to use the probe when performing levelling due to making sure you use the same Z reference point for everything. less headaches

It means that the temperatures expected were consistent over the course of the tuning. Depending on how off it was it might or might not be a problem. The algorithm is new and may have some room for improvement, so thanks for the report. If it's working well though and maintains a steady temp you should be fine to use it.

I understand now. That makes sense. They aren't typically rated to handle heater loads.

Thank you, T0 solve the error!