@fcwilt said in Upgrade firmware 2.02(RTOS) to 3.2.2 error:
Hi,
As I recall you have to upgrade first to 3.0.0.
All of the steps are documented somewhere.
Frederick
It works .. Thanks for the Help !
@fcwilt said in Upgrade firmware 2.02(RTOS) to 3.2.2 error:
Hi,
As I recall you have to upgrade first to 3.0.0.
All of the steps are documented somewhere.
Frederick
It works .. Thanks for the Help !
Changed crimp, terminals, wiring with the same thermistator..
Now, i changed thermistor with the same wiring/terminals and works fine.. So it was the thermistor.
The thermistor its new.. i open the box three days ago.. Very weird..
@Phaedrux Thanks for the help.
Changed crimp, terminals, wiring with the same thermistator..
Now, i changed thermistor with the same wiring/terminals and works fine.. So it was the thermistor.
The thermistor its new.. i open the box three days ago.. Very weird..
@Phaedrux Thanks for the help.
I will try changing the thermistor for a new one ! Thanks for the help and your time !! I keep you updated
@deckingman Could any other wire be making noise? because the thermistor is new, and the wiring its from stock on this moment.
I did it.. and i get same result.
bad crimp ? bad cable ?
im using cat5e and terminals crimped
i will upload photos
Could be possible about power supply not working well ?
Today i try to print cube from https://duet3d.dozuki.com/Guide/Ender+3+Pro+and+Duet+Maestro+Guide+Part+4:+Calibration/40#s179
and i get this error message
really need help
I recorded the moment..
I keep getting a warning ...