Topics created by id104335409

@id104335409 Perhaps take a look at this post: https://forum.duet3d.com/topic/14518/trying-to-set-starting-point-that-is-not-at-the-end-stops/13?_=1582653501451

There have been a couple threads similar to yours recently, they may also be worth checking out.

https://forum.duet3d.com/topic/13946/hypercube-fusion-movement-help?=1582657700774
https://forum.duet3d.com/topic/14291/paneldue-and-motors-will-not-function-properly-with-duet-wifi?=1582657700779

@id104335409 Yes there is. But you can use M302 to allow cold extrusion.

Found it:
M574 X1 S1 P"!xstop" that ! turns normally closed switches to normally open (active high to active low)
successfully homed
hope that helps someone else as well

@id104335409 said in Stepper motors not turning:

If I have more questions should I just post here or make a separate post?

Glad you got it working. I’d tend to say start a new thread for each individual issue, otherwise threads can get very long and convoluted. Make sure you state Machine setup, firmware version and post current config each time, this goes a long way to getting problems resolved quickly, as people have the context for the problem. Or see https://forum.duet3d.com/topic/5909/guide-for-posting-requests-for-help

Ian

Assuming they are plugged into the Dual Z ports on the Duet?

Pick one motor. If the pins in the connector (at the board end) are 1234, make them 3412.

Then test. If they are both going the right way, done. If both are now going the wrong way, reverse just the Z axis driver in the config.g file.