Topics created by Jman3

@Phaedrux I repeated the e step calibration 3 or 4 times so I feel pretty good about it.

I posted the same thing on another site and someone mentioned that retraction settings can cause this same issue. I double checked my settings and I had an override on my ABS settings that was still 2mm. I lowered it to .5 then tested it last night and the print looked perfect this morning. So the issue was my retraction setting surprisingly.

Sorry for the late update I ran into some other issues I needed to take care of.

So it looks like I got this working after I fixed a few issues. I managed to print a temp tower without issue, maybe I'll have problems in the future with other prints.

Installed a mount close by the extruder (around 1" of distance between the sprite pro extruder Removed my filament-error.g (it was trying to pause then run filament-error.g) Used the BTT recomended g-code but adjusted E value to 22 Changed my retraction speed to 60mm/s

Here is the g-code I'm using

; Filament Monitor (Filament Runout Sensor, Big Tree Tech - Smart Filament Sensor V2) M591 D0 P7 C"io0.in" L2.88 R75:125 S2 E22

It turns out I must have burned up my Out6 while poking around with a multimeter. I switched to Out3 and the hotend fan thermostatic control is working as it should now.

@droftarts Thank you so much for the help! I'm printing and things are working well!

Screenshot_20231123_115030_Gallery.jpg