Topics created by JuL

OK. Thank you

My bad, I didn't expect g92 set position AND flag as homed. Thx for pointing me my mistake

I inverted gpio pins 2, 4 and 6 under the pi board (so no more in the ribbon cable) and solder 5v directly on it. Works like I wanted. Thx

@Phaedrux OK tanks

@bearer 👍

@tjb1 because I want to wait at least 5 minutes with the fan on to cool the part and bed. Depending on the print temp the hotend may have cooled off by then or not.

I tried too. M121 just blocks the macro wherever it is.

@fcwilt said in Desactivate M120 on nested macro call:

How about putting multiple M291/M98 pairs in one macro and calling another.

I'll maybe do that (or one big with multiple cycle and M291) or if there is a GOTO like gcode but I don't think so.

Thx

I just tried to launch an already made gcode without the BIP command (remove by hand)
TADA !!! No more disconnection