Topics created by mhallett

Thanks, You might want to ad this to the Wiki page for setting up the Z probe.

never mind I had a brain fart. Common sense would tell you to look at the coordinates on the dam marker dot and it tells you exactly where it was.

Just when I thought I killed the last hornet finally getting the 2130 to cooperate (more like me to cooperate) I have this same endstop issue while using the expansion port. I will try the above suggestions and report my findings. I have the latest 2.0FW

See "Using external drivers" on the wiki.

Swapping the X and Y motors, either the connections or in software, switches the coordinate system between left hand and right hand. In a right hand coordinate system (which is what slicers assume), the +Y direction is rotated 90 degrees anticlockwise from the +X direction as seen from above.

Thanks for the help. I am new to this all. I am coming from delta and repeater firmware. so it is not even close to what I am used to.bed and hot ends go in this week so hopefully by Saturday I can get a first print. I also need to find a way to adjust the timing on the leadscrews. I think they are off from about 5-10mm from each other. that will level everything out.

What we are saying is to only use 3 Acme rods that way you can't twist the bed which is what commonly happens if you use one in each corner think of a 4 legged stand as opposed to a camera tripod which is the most stable