Topics created by MichaelKallner

@MichaelKallner the change logs detail what changes have been made between 3.4 and 3.5. That is quite a big jump so there will be a fair few changes however most won't apply to your specific machine config.
https://github.com/Duet3D/RepRapFirmware/wiki/Changelog-RRF-3.x

@MichaelKallner this could be caused by a bad VIN connection or a failing PSU. Check that the screws on the VIN terminal block on the Duet are tight and that the VIN cable shows no signs of charring.

@phaedrux
Hello, thank you very much for your help. Soldering the 1K resistor directly in front of the sensor board helped. I have a stable signal. Tested several times, flawless. I also think that the connected shielding also helps.

Thank you again. 🙂

Slice's published numbers for Magnum+ printing ABS were 91mm³/s, printing at 300°C, 60 degrees above the manufacturer-recommended print temperature (53mm³/s if printed at the recommended temperature of 240°C).
CHT nozzle supposedly gives 30%+ higher volumetric flow rate (probably more for a 1.0mm nozzle).

Super Volcano claims a max volumetric flow rate of 110mm³/s.

@engikeneer
Thanks for the top tip 🙂 i will Test it an Reply