Topics created by Mr Yod

@gloomyandy
Ok, now (after calibrating it at Z3) it doesn't give the error.

But now it does all 5 loops because it doesn't manage to be consistent. 😬
EDIT: going slower doesn't have problems.
I'll also try to move the coil further away from the extruder.

Then I'll have to understand how to make the scanning without lifting and lowering the bed on every point (just removing the Z-999999 from G30 makes it ignore said command).

@Phaedrux said in Can't connect Duet 3 6HC v1.0 after updating to RRF 3.5.2:

Can you try chrome?

I could, but I don't want to risk another brick + reflash, sorry... 😅

If I'll remember I'll do it in the next update.

@fcwilt said in Possible bug with local variables use in config.g?:

@Mr-Yod

I've always used {var.variable_name} rather than just {variable_name}

Frederick

🤦

You are righ... 😅

@dc42 Yes, I saw that: over one hour for a DC 300*300 bed autotune and less than 10 minutes for the hotend... 😅

@mr-yod said in Laser that worked in the past and should work, but doesn't:

@o_lampe Nope: still with 2.05

Maybe when it worked I used a previous version of RRF, but I'm not sure.

Disclaimer: I know that I upgraded from a previous version to the 2.05, what I'm not sure about is if I used or not the laser after the firmware upgrade. 😃

@Mr-Yod glad its fixed!

@mr-yod said in Magnetic vs Laser filament monitor:

@fma said in Magnetic vs Laser filament monitor:

Did you see this design?

https://www.thingiverse.com/thing:3241561

LOL: it's laser AND magnetic! 😃

It still seems similar with the one I linked (and the others linked in that thingiverse page).
But my question (that I forgot to address in the OP and that bot reminded me) is: is this system with laser sensor on a bearing reliable?

I believe it is but we will find out soon enough. There will probably be a few versions built shortly.