@droftarts The fuse was the problem. Thanks!

@ObiWan2Print I read the information here: https://docs.duet3d.com/User_manual/Connecting_hardware/Fans_connecting

However, it is not clear if you have to set jumpers for VIN and if this is what is used with 24V fans. Can someone clarify?

@droftarts The fuse was the problem. Thanks!

@droftarts Thanks! Fuse is blown. Will replace it and get back here with results.

I had an accident where the wires on the extruder cooling fan was pulled out during a print. After the accident, I tried installing a new fan and could not get the fan to turn on. None of the fan power plugs seem to work. Is there a way to check if this can be fixed?

I am using a 115/230Vac, 24Vdc, 14.6A, 350W power supply with Duet 2 wifi board and Deux5 board connected. I want to use the Deux5 board to run a 24V fan. Do I need to solder some jumpers or can I just plug in the fans and run them with the appropriate gcode?

@Exerqtor Thanks for the replies and info. Just to clarify I am using the Duet 3 MB 6HC board and want to know if I can just plug the extruder/hotend control board output from the Stealthburner into the Duet 3 MB and control the extruder this way. If not is it possible to use the extruder with modifications?

@oliof said in Stealthburner Extruder for Troodon 2.0 used with Duet boards:

fly rrf36

Thanks for the replies and info. Just to clarify I am using the Duet 3 MB 6HC board and want to know if I can just plug the extruder/hotend control board output from the Stealthburner into the Duet 3 MB and control the extruder this way. If not is it possible to use the extruder with modifications?

Is it possible to use the Stealthburner Extruders with the Duet boards? I have a Railcore 2 system and wanted to see if I could use a Stealthburner Extruder.

So I fixed all my bed leveling problems and got the Railcore 2 to print with a Mosquito Magnum extruder. Now I have a scaling problem. When I print a 20mm cube from thingaverse it ends up being a 40mm cube. I tried halving the values in the config file for M92 X, Y and Z and it printed the cube at 20mm but my print bed size is also half what it used to be. How do I fix this problem of scaling?

So I am having problems getting my bed to level. The probe seems to be working but after running G32 I get the error message: g32
Error: Some computed corrections exceed configured limit of 2.00mm: 0.463 4.487 -1.012. Any suggestions on how to resolve this error?