Best posts made by oc_geek

For Europe this is an option for ordering the Mini 2+
https://www.dold-mechatronik.de/Duet-3-Expansion-Mini-2_1

no it does not fix the issue

Wonder why any operation with those varaibles results in an error

e.g. {job.filePosition / job.file.size}

i also tried ( same

any hints ?

i was expecting those to be Numerical Value

fwiw this is 3.3 RC3...

@droftarts @dc42

Configuration is :

• Rel 3.3 beta 2+2
• Forced SpreadCycle (D2)
• Mesh active

Still getting layer shifts
(see below at back after couple of layers)
I stopped the print - it produced a sound when that happened

Dumps:

• M569 report
• M122 report
• config.g

@MikeS the SPI appears to do not support interrupts, yes

@dc42 good catch !

that might also be the issue behind slicer output .g files not completing the upload when the heater is turned on. They reach 100% but then start over again and again...
thanks