Topics created by PeteIHughes

@PeteIHughes said in Duet Wifi Powers Off when turning on Hot End:

Thanks for the Ideas guys.

Checked the resistance at 21.6 ohms, so I am guessing that's close enough.

While checking the PSU, ran into a "small" problem.
How can I test a few amps of load on it?

I thought, simple, just connect the heater cartridge directly across it.
I "probably" should have been testing the 24v side, but no,
somehow I connected it across 115vac.
Turns out the heater cartridge probably worked, as it went from
room temp to white hot in less than a second.
I'll be ordering a new PSU this weekend.☹

Looking on the bright side, It was probably that anyway 🙂

Report back in a few days

Pete

😳
I hope it is the PSU and not a MOSFET on the board.
Good luck.

@PeteIHughes said in BLTouch will not deploy:

@DIY-O-Sphere
That worked !!!!!!!
so my guess is that my deploy probe "g" file is bad.
It is all lower case.
could that be it ?

No, lowercase is fine. The difference is the M280 P parameter. In RRF2, the P parameter is the logical pin number, which for heater pins is the same as the heater number. In RRF3 is it the number of the servo device that you created using the M950 S command.