Topics created by po3plestorm

@oliof well that did it, thanks!\

heres the link for anyone else with the same issue
https://github.com/Duet3D/RepRapFirmware/releases

@rushmere3d Oh good tip. Under experimental settings on cura I had experiemental bridge settings enabled. Those then have fan speeds and flow rates for fan settings. I just adjusted them to something more resonable as the 100% fan speed is really loud.
now looking at it, the settings are pretty interesting now that I look at them and after playing with it I found bridge settings make a huge difference.

Link to the settings description:
https://community.ultimaker.com/topic/22195-introducing-the-experimental-bridging-settings/

@po3plestorm I ened up just making a macro, ill update when the full release comes out.

Macro: Mount 2nd SD Card

M21 P1 ; mount the sd card

@phaedrux @jay_s_uk Hey just wanted to thank you guys for helping me out. I found the problem.

the entire pack of heater cartridges I have are just bad. I got a huge pack on amazon and I just tested them on my room mates 3d printer and not a single one worked. The resistance on them is totally fine, they look fine, but all 8 of them in the pack are just bad, no clue how.

Im so angry but at least I got down to the bottom of it.

Post your config.g and homall. You slicer start gcode. The results of M122 and the gcode file that won't print. Without that we're just guessing.

btw cloned or genuine duet?

when you say two blue leds, that is normally Vin and the wifi - the wifi wouldn't work with the chip in question damaged?

(edit: if so, please ref https://duet3d.dozuki.com/Wiki/Hardware_Overview#Section_LED_indications and tell us which LEDs are on as the colour may well be misleading)