Topics created by TonyGR

@droftarts i had 900 and tested 1200 and 600 with no change. i will check some more but i had never printed with the corners in this orientation since most of my prints are 100 rounded. Since my motors are original LDO Nema 17 w/1.8deg and a high amp rating i am running them X2050.00 Y2050.00 Z1000.00 and they hardly get hot even after 15hours of print time.

@timcurtis67 i had checked the belt slack also as also proper tension and i think i am ok on this, but i will try once again.

@tonygr The web interface displays 3 time estimates. One based on filament usage, another based on file usage and yet another based on layer time. Are all 3 estimates "wrong" or just one of them?

The best way to get an accurate estimate of how long a print will take is to run it in simulation mode first (right click on the file).

@TonyGR don't forget about me 😞