Topics created by YYCSparks

@Nightowl thank you for the reply.

What I want todo is basically set a macro that will take the bit over to the tool length probe location and measure the tool length and set the offset so that Z0 is the top of the spoilboard.
Currently when I probe using the tool length probe it sets an offset between the current Z and the probed.
I am not sure how or where to tell it how far the probe switch is from the top of the spoilboard and I think that’s my issue.
The job setup and stock settings are fine.

@Nightowl thanks for the reply.

I am using a Duet3 Mini+ with version 3.4.5 in SBC mode.

When I run job with the RepRap post in Fusion 360 jobs work okay but I am trying to understand what is happening in Carbide Create 6.52 that is causing the cuts into the material.

@YYCSparks said in Silly homing problem:

it was set wrong causing the Z axis to see the probe as tripped and wouldn’t home.

That'll do it 😁

@droftarts so is there anyway to use Lightburn live with the Duet or would it be Generate Gcode upload then burn.
I am thinking about things like framing or setting focus are easier with the software live from what I have seen.

@markz its alive, Thank you for your help and advice.

https://youtube.com/shorts/x23cIedPRH4?feature=share

Jesse

@dc42 @Phaedrux Thanks guys I added a Power Supply for the RPi

@yycsparks said in Homing issue with Dual endstop:

Thank you for sharing the video that is really slick, and my config should result in the same result I assume?

Well if your printer has two Y steppers and three Z steppers you should see much that same.

On a side note what printer is that?

Something I designed myself. I was reading about different types of printers and was intrigued with the "MarkForged" kinematics. So I set out to build one. I also chose to try belt drive for the Z axis - very pleased with the result.

Frederick

@oliof Thank you very much for your advise it worked great.

@nightowl999 thank you that looks perfect. Really appreciate it.