Yes, that's what I have on my Tronxy printer.

It has dual independent Z motors, and I probe via G32 near the screws and it relevels the bed properly.

@elliott-griffiths said in Where to find the motor side connectors used on Nema17s?:

Essentially we have a piece of equipment that doesn't support reversing the extruder at the moment

What's wrong with M569 ? Are you looking to use exactly the same config.g file with different extruders?

@flux said in Connect servo motor to Duet2Wifi with Duex5:

i can use a servo OR a heater, but don't booth a same time on a same channel?

Correct.