Duet3D Logo Duet3D
    • Tags
    • Documentation
    • Order
    • Register
    • Login
    1. Home
    2. Tags
    3. smart-effector
    Log in to post
    • All categories
    • 3mmundefined

      Fan1 disappeared, V6 hotend temp problem, loss of EtherNet conn

      Tuning and tweaking
      • duet3d ethernet controller duet v1.02 controller smart-effector e3d v6 hot end e3d-v6 hotend e3d v6 hot-end • • 3mm
      9
      0
      Votes
      9
      Posts
      1.2k
      Views

      dc42undefined

      @3mm said in Fan1 disappeared, V6 hotend temp problem, loss of EtherNet conn:

      @dc42

      Ok, but what about the 11.5Vdc reference issue? What does that effect directly...its important enough to display its value on the DWC? Why is it reading low? If its not affecting anything, why care? Its either a SW issue or the chip is out of spec.

      I don't understand why that reading is low. The tolerance on that reading is +/-5%, but that include the 3% tolerance of the 3.3V reference. If the 3.3V rail is accurate as your meter suggests, the reading should be within +/-2%. The accuracy depends on the ADC accuracy (which is normally very good once the firmware has run auto calibration on it) and the values of R60 and R61.

      2nd Problem: EtherNet Disconnecting.

      Ethernet disconnection issues are usually caused by either a bad Ethernet cable or an IP address conflict. Are you using a static IP address assignment, or DHCP? Which firmware version are you running?

    • 3mmundefined

      Kossel is Printing!!

      General Discussion
      • anycubic delta anycubic kossel duet3d ethernet paneldue smart-effector hayden magball rods • • 3mm
      4
      3
      Votes
      4
      Posts
      1.0k
      Views

      3mmundefined

      @danal, @Juice

      Thanks! : ))

      3mm

    • 3mmundefined

      Which E3D V6 Hot-End for Smart-Effector?

      Smart effector for delta printers
      • smart-effector e3d v6 hot-end e3d hot-end • • 3mm
      3
      0
      Votes
      3
      Posts
      857
      Views

      number40fanundefined

      @3mm I was kind of at a loss too when I purchased my Smart Effector. Never owned a single E3D product. What I purchased that worked for me (from Filastruder) was:

      Cartridge Style Upgrade/Parts that includes the Block, Thermistor and sock.
      E3D heat-break v6 1.75mm version.

      I can't remember if I bought the heater cartridge at the time or not, but I think I just reused my old one. I was at the point of switching from 12V to 24V too.

      I already owned some nozzles that I knew would fit, but if you don't think you do, it might be another thing you need to add.