Bltouch setup need help
-
@Elvis0z said in Bltouch setup need help:
Error: Z probe was not triggered during probing move
Error: Homing failedDouble check your white wire.
M558 P9 C"^zprobe.in" H5 F60 T6000 A10 R0.5
You can try removing the^in front of zprobe.in -
Thanks heaps hey. I'm futher ahead than I have been. At least its moving and the probe works with M401 and 2. That did not work befor
-
@Elvis0z said in Bltouch setup need help:
Hey guys need help to set this up its a v1.0 bltouch.
Is this a version with the trace to cut or does it come with the resistor? It's been a long time since I've seen anyone with a V1, so I'm wondering if it matters in this case. If it's a new Duet 1.04 it can't be hurt by 5v, but perhaps there is something in the BLtouch that will not trigger. If removing the ^ and checking your white wire is fruitless, maybe look into the trace/resistor
-
No I replaced it with a v3.1 that I had
-
If I send command M401 and M402 it triggers
-
You mean it deploys and retracts?
When you send G30 does the pin deploy?
-
I get this error when sending G30
G30Error: G30: Insufficient axes homed for bed probing
-
Yep deploys and retracts that is for the M401 M402 commands
-
Ok home X and Y first, move the print head to the center and then send G30. Does the pin deploy? Does the Z axis move? If you touch the pin does the Z axis stop?
-
@Elvis0z said in Bltouch setup need help:
Error: G30: Insufficient axes homed for bed probing
Yep deployed and red light went out and got the error
Error: G30: Insufficient axes homed for bed probing
-
@Elvis0z please remove
M307 H3 A-1 C-1 D-1
this not valid in RRF3 any more.Edit: this is the source: https://duet3d.dozuki.com/Wiki/RepRapFirmware_3_overview#Section_M307
-
@JoergS5
Yep removed -
@Elvis0z said in Bltouch setup need help:
Error: G30: Insufficient axes homed for bed probing
Just to make sure, the files you are editing are in the /sys folder, right?
-
Yep
-
Can you upload the actual files to your post? config.g homeall.g homex.g homey.g homez.g deployprobe.g retractprobe.g
And maybe a photo of your wiring?
-
Not sure what you mean "Actual files" or how to do it not copy paste?
-
In the /sys folder select the files and then right click and download. Then drag the files onto the post text box in the forum to upload.
-
-
Thank you for all the help. I have to go out for a while will be back
Cheers -
Can you send M98 P"config.g" in the gcode console and report the results?
