@oliof

Hello ,
here is my solution for the 6XD board

Hello ,

I think that an Ethercat or Profinet bus would be very helpful. There would be many possibilities to work with a PLC.!

Hello everyone,
is there a guide on how to use the Duet 6HC as an expansion board with the 6XD, and how can I configure it?

@oliof

Hello ,
here is my solution for the 6XD board

@oliof

I have fix it !

@oliof

ello ,
I have now got a replacement as the last fan has burnt out.

DC7-24V brushless turbo fan motor 100000 rpm high speed aluminium alloy impeller with brushless motor and speed controller

I have now connected the fan direnkt to the 24V power supply and I can control it very well with the potentiometer

I have now measured the voltage at the potentiometer and between the red and black cable are 5V

The yellow cable should be the PWM signal.

How can I now control this fan with the Duet 6xd?

Witch pins ?

@oliof

Hello ,
I have requested the data sheet from the manufacturer.

@oliof

Yes !

@Phaedrux

Hello ,
I have
+24V at Out5 / V_OutLC1
-Out 5 / GND
PWM at Out 5 / out5-

in config.g

M950 F2 C‘!out5’ Q1000
M106 P2 S0.0 H-1 C ‘Blower’

@Phaedrux

I have connected the fan and set the parameter Q1000. If I set the speed in the DWC to 95%, the motor burns out!

@Phaedrux Yes, I have read it but not understood it.
The fan has 3 pins 1x +24v 1x - 1x pwm

Which is the pwm output?
Outx-
Or outx.tach

@Phaedrux
Which pins can I use?