Thank You it Works.
Latest posts made by Zseven
-
RE: Multiple Analog ZProbe
Hello ,
yes, I have installed a load cell in each tool which outputs an analog value.
The background is that I want to measure the tool offset and the filament pressure on the nozzle.
-
RE: Multiple Analog ZProbe
@oliof
3 Tool whit analoge z-probe (Pessure Sensor) -
RE: Multiple Analog ZProbe
Hello ,
I have the Duet 3 6XD
I found this in the documentation:
From RRF 3.1.0, you can define multiple probes.The K parameter in M558 selects the Z probe number. If there is no K parameter then 0 is used. You can ignore this parameter if you have only one Z probe. Z probe #0 can use probe types 0, 1, 2, 3, 5, 8, 9 or 10. All other probes must be probe type 0, 8, 9 or 10.
But why is that so ?
I need 3x type 2Translated with DeepL.com (free version)
-
Multiple Analog ZProbe
Hello
why can I only set 1x analogue sample?
Why are not more supported? -
RE: define an analog input?
@o_lampe
Hello ,but is that basically possible ?
-
define an analog input?
Hello ,
I have a question. How can I define an analog input? For example, it should switch when 3.2 volts are reached?
Is there a solution ?
-
Giop Pin Raspberry Pi
Hello , is it possible to control a giop pin of the raspberry via Duet ? I can't find anything in the documentation.
-
PLC ethercat codesys
Hello ,
I think that an Ethercat or Profinet bus would be very helpful. There would be many possibilities to work with a PLC.!