We will be patiently waiting for your fork with all of the fixes, Sunshine

Hey,
Just want some input, how have you adjusted you start gcode for the probe. What temps are your probing at and how have you adjusted your start gcode to accommodate

Thanks

Setting>User Interface

There is a fan setting letting you choose which you would like visible. Select which you would like then select "Apply Setting".

@oliof I can provide config shortly but shouldnt affect the initial connection of CAN (especially if other can devices are connecting just fine) and M122 of the board shows time out/ no connection.

@dc42 The red status light is blinking rapidly like it hasnt synced with the CAN.

Also yes there 5v supplied, I04 5v and ground are being used.

@droftarts It is the last board and is terminated.

Hardware Used
Duet3 Mini 5+
2 1HCL boards

All working properly

Added the Scanning Probe and cant get it to connect to can.

trouble Shooting already done
-Set the delay in the config as directed
-Added the code for the probe from the docs
-Checked that everything is updated to 3.5.1
-Plugged the SZP board directly into the Duet 3 rather than off the second 1HCL board
-Hit the reset button on the board
-checked continuity from the plug at the Duet3 all the way to the pads on the back of the SZP High and Low both good
-Checked it with and without the coil connected.

At this point I believe I have a defective board. does anyone have any ideas on what else I could try?

Currently trying to set up the Duet Scanning Probe into my system. I'm currently running a Duet 3 IDEX system with full size tool boards (as in not the roto). I have the probe and Z Scanning board but since there is not can out on the tool board I want to make sure I splice into the CAN correctly. Im running the twisted pairs from the tool distribution board to the tool board that come with the newer distribution boards.

Is there a suggested way to splice it in. I just want to make sure I don't cause additional issues when doing this.

I have been looking into controlling when one of my power supplies is on since it has a fan that is away on and can get annoying.

This is the power supply I want to power down and I also have a 5v power supply just for the raspberry that is fanless and can stay on.
https://www.meanwell.com/productPdf.aspx?i=469

At this point, I'm just looking for some insight into how someone is using it so I don't screw something up.

Cheers,

Nope that looks good. Can you post your full config?

Not sure if you are aware but there are thousands of different printer setups that have to designed around. You can't expect everything to be plug and play, if that is what you want buy a prebuilt unit and never modify it. Spamming is not the answer, best of luck.

Do you have a config override file?

If you do check to see if it has any bed offsets saved there. If it does comment them out an see if it solves the issue and let me know.

We will be patiently waiting for your fork with all of the fixes, Sunshine