@ajlapp Looks like M42 is the correct direction
The frame is thick wall steel square tubing with a pad welded to one face. That face was machined flat with the bearing blocks mounts and other features all in one shot.
I’m using a E3D Volcan with a 1.2mm nozzle and 3mm PLA for now.
We had a project planned for this that has since dried up so for now we’ll just be using it as a general printer.
Ha! Why do I have my M208 set to Z-780??
This would have saved my buns twice now.....I never even saw that.
X and Y are set correctly...go figure.
Been working on this beast sporadically for almost a year...should be printing this week finally. Mind the mess and dangling wires!
Working! 24v and the thermistor line in config did the trick.
also you ignored the very big warning for M584 to unmap the old assignment
@ajlapp yes that M584 is indeed a valid approach
I think both of those are workable solutions.
I should be operational sometime next week.
I’ll load some pics once the magic starts.