Topics created by kotuo

@droftarts @phaedrux Thank you for your kind remarks to my ignorance.
I finished setting up the M671 today. The result on Bed.g looks like this.
Bed image:スクリーンショット 2021-12-07 192441.png
G32Results：G32
Manual corrections required: 0.00 turn up (0.00mm) 0.19 turn down (0.09mm) 0.13 turn down (0.07mm) 0.19 turn down (0.10mm)
Thank you for telling us.
I don't think I could have done so much with my knowledge.

@t3p3tony Thank you for your reply.
Thank you for the clear site on C parameters.
I will refer to it.

@dc42 Thank you for your reply!
I will lower the motor current to 600 with RRF and upload the zip file to Duet.

Sorry for the delay!
I contacted the manufacturer of my old 3D printer and they told me that the optical end stop switch I have is designed for that purpose only and cannot be used for Duet.
I would like to express my sincere thanks to all of you for your co-operation.
I think I have not enough experience and knowledge to use this optical end stop switch for Duet, so I would like to use a normally open microswitch which I have prepared as a spare.
We'll meet again somewhere else.

@kotuo, you lucked out 🙂

That's great to hear.

People who have seen this thread
Thank you for posting your solution in this thread.
I've bought an Ethernet at E3d today.
It's my first Duet and I was scared of the future of modifying and breaking it, so I chose the easiest and safest way to connect the Ethernet to my wifi router.