Topics created by Milan

What type of Z probe do you have, and how have you connected it to the Duet?

Ok , I've taken 3v from external source, that could be the reason, coz my Duet 3.3V rail conked off

i would not dismiss the pinching. it has to be something mechanical, otherwise it would the entire top layer.

@Milan Nice to hear that you have the solution!!👏

Thankyou , Its working fine now ...after changing the parameter of the M569

Is anything getting hot? Check the processor, WiFi module, and SD card in particular.

In firmware 2.03 and earlier, when you create axes the endstop inputs are allocated automatically. So if you create axes U and V in your M584 command then U will use the E0 input and V will use the E1 input.

In firmware 3.0 beta you have to allocate endstops for additional axes and specify the input pins using M574.

@thomss said in duetwifi breakout board and bltouch wiring:

@dc42 said in duetwifi breakout board and bltouch wiring:

The breakout board inverts the heater/servo signals to be the "right way up", just as on the DueX boards, so you won't need the I1 parameter on the M208 commands.

do i understand right, that: "The PWM heater output on the Duet acts on the negative side, to pull it low, rather than pulling it high" but with the aid of an breakout board it will be the other way (pull it high, rather than pulling it low)

Yes.

@dc42 said in Connecting duex5 and breakout board with Duetwifi:

CONN_LCD connector

Thankyou so much @dc42 , will try connecting the same,
I would be using breakout board for XYZU axis and 2 extruders (E1 & E2) from CONN_LCD, if any issue then once again I would bother you - Thanks a lot