Topics created by Mugga

Hi Mugga,

I use the same configuration as you.

For me the following code work fine (based on your inspiration):

M308 S0 P"bedtemp" Y"thermistor" A"Bed Pad" T100000 B3950 ; configure sensor 0 as thermistor on pin bedtemp M308 S4 P"e2temp" Y"thermistor" A"Bed Plate" T98801 B4185 ; configure sensor 4 as thermistor on pin e0temp M950 H0 C"bedheat" T4 ; create bed heater output on bedheat and map it to sensor 4 M140 H0 ; map heated bed to heater 0 M143 H0 P0 T0 A2 S110 C0 ; Regulate (A2) bed heater (H0) to have pad sensor below 110°C. Use Heater monitor P0 for it M143 H0 P1 T0 A0 S120 C0 ; Shut off (A1) bed heater (H0) if pad sensor exceeds 120°C. Use Heater monitor P1 for it M307 H0 B0 S1.00 ; disable bang-bang mode for the bed heater and set PWM limit

00f90205-9576-41e8-bc3e-fcd7a38a47dd-image.png

Thx for the clarification. Like I said, I already got it working in S3D.
These are the settings I'm currently using:
M207 S4.5 R-0.05 F4800 T1800 Z0.20

But now it also works with Slic3r. Just used the newest beta version of Slic3r PE instead of the stable release.

@RodrigoRMaraujo for you the wiki has some info at https://duet3d.dozuki.com/Wiki/Connecting_a_Z_probe

There isn't a command run when power is restored.

One option would be for you to arrange for a spare endstop input to be triggered when VIN power is applied or removed. That could be done using an NPN transistor and 2 resistors. Then you could set up M581 triggers to act on changes to that endstop input state.