Best posts made by Pyper

@oliof
as if on cue!
https://youtu.be/J1wz8S9rTI8?si=336JVNOTmP4rH9oB

@phaedrux
Ok, after reversing the Z motor and the endstops, it homed on all axis!
Thank you so much, I'm sure everyone is thinking "how does this guy drive a car?" haha
Onward!

@rjenkinsgb
Lord have mercy I am embarrassed to say the problem was in my config.g file. I think I copy/pasted someone else's BLTouch settings and didn't update them for my own printer. It is working better now! Using this guide to set it up:
https://duet3d.dozuki.com/Wiki/Test_and_calibrate_the_Z_probe

@droftarts
I think they bought this awhile back but are only just now getting around to installing it.

Well, I keep trying to post the contents from those commands but it gets flagged as spam or something..

@droftarts
Thank you for helping.

M115 returns "FIRMWARE_NAME: RepRapFirmware for Duet 2 WiFi/Ethernet FIRMWARE_VERSION: 2.0(RTOS) ELECTRONICS: Duet WiFi 1.02 or later FIRMWARE_DATE: 2018-06-05b3<LF>ok<LF>"

I downloaded the RRF2.0 link you posted, deleted the existing www folder, and created a new one with the DuetWebControl-SD-2.07.zip files.

I still get the same error. Not sure what is going on.

I formatted the SD card with the suggested utility to FAT32.

Arg!

@dc42
The complete message is "Your Duet rejected the HTTP request: page not found"

I am trying to use the Duet 2 wifi for the first time. I have connected via YAT and it says I have firmware version 2.0. I need to upgrade but I can't connect via my web browser. The duet is on the wifi and I can see what the address is with M552. But when I go to the address it says "Your Duet rejected the HTTP request". How do I fix that?

@phaedrux
Success!
Thank you so much (all)!
I can confirm M115 returns 3.2.2 in YAT
Onward!