Topics created by ractorIII

@owend - thanks! this is very helpful. I'm going to test today this all today, including parking the head.

@ractorIII If it's a mixing hot end then think of it as single digit percentages divide by 100. So E0.01:0.99 works. As does E0.15:0:15:0.70. But I'm pretty sure that you can't go to more than 2 decimal places (at least you never could unless something has changed recently).

If you use multiple extruders in a push - pull arrangement then the mixing ratio would be 1:00:1.00

Edit. I've just noticed you signature and realise that you might not have a hot end as such. In which case substitute mixing hot end with "multiple inputs, single output".

@fcwilt

The N0 etc is line numbers - I find it helpful for troubleshooting.

I’ll have to report back with specifics, but - my m203 X and Y values are 6000, for Z and E they are lower.

Thanks, It helped me find a typo in M208 as declared in config.g

Issue closed.

I guess that does work - I was looking feedback on the screen - like maybe 'ok' if it ran the command.

I'll increase the maximum number of extruder drivers to 7 in the next RRF3 build for Duet 2.