@droftarts I did check that before and I always put loctite on those. the problem was the motor. I got weak over the year. I never seen that befor. I did buy the motor very cheap though.
@gloomyandy I put it there ill add it here too maybe it helps someone some day m122.txt
m955 p0
Accelerometer 0 type LIS3DH with orientation 41 samples at 1344Hz with 10-bit resolution, SPI frequency 1000000
@nightowl999 well looks like if you have a ups module you can manage the power recovery very well even without M911. in trigger file you can pause the printer or cnc with G25 and it makes sys/resurrect.g
after that you can just recover with m916. I will write guide if it works, I think you can use it. those ups are very cheap.
@oliof Basically any internally temperature compensated probe will do (with proper output type obviously). I did some research once and Prusa's was cheapest one that works with 5V power supply (original prusa board back then, not required for duet) and is temp. compensated and in 8mm diameter).
