Bltouch setup need help
-
@Elvis0z please remove
M307 H3 A-1 C-1 D-1
this not valid in RRF3 any more.Edit: this is the source: https://duet3d.dozuki.com/Wiki/RepRapFirmware_3_overview#Section_M307
-
@JoergS5
Yep removed -
@Elvis0z said in Bltouch setup need help:
Error: G30: Insufficient axes homed for bed probing
Just to make sure, the files you are editing are in the /sys folder, right?
-
Yep
-
Can you upload the actual files to your post? config.g homeall.g homex.g homey.g homez.g deployprobe.g retractprobe.g
And maybe a photo of your wiring?
-
Not sure what you mean "Actual files" or how to do it not copy paste?
-
In the /sys folder select the files and then right click and download. Then drag the files onto the post text box in the forum to upload.
-
-
Thank you for all the help. I have to go out for a while will be back
Cheers -
Can you send M98 P"config.g" in the gcode console and report the results?
-
@Phaedrux yep will do soon as I'm back home
-
I am not sure whether it's a problem that retractprobe.g doesn't have a CRLF at the last line.
-
M98 P"config.g"
HTTP is enabled on port 80
FTP is enabled on port 21
TELNET is disabled
Error: bad model parameters -
@JoergS5 CRLF not sure what that is
-
@Elvis0z carriage return and line feed. In other words press enter.
-
@Elvis0z please try
G31 P25 X41.0 Y10.0 Z0.0
instead of
G31 P25 X+41 Y+10 Z0.0
and run M98 P"config.g" again whether the bad model parameters is still there. -
HTTP is enabled on port 80
FTP is enabled on port 21
TELNET is disabled
Error: bad model parameters -
@Elvis0z ok, somewhere is a syntax error in the config.g, but I cannot see it.
-
-
@Elvis0z for BLTouch in most cases the value is P25. P9 was the parameter for M558. G31 P25 means sensitivity.
