Duet3D Logo Duet3D
    • Tags
    • Documentation
    • Order
    • Register
    • Login
    1. Home
    2. Gost101
    3. Topics
    • Profile
    • Following 0
    • Followers 0
    • Topics 6
    • Posts 184
    • Best 3
    • Controversial 0
    • Groups 0

    Topics created by Gost101

    • Gost101undefined

      Duet Wifi Closed Loop and Panel Due

      Accessories and Add-ons
      • breakout board closed loop help panel due setup wiring • • Gost101
      23
      0
      Votes
      23
      Posts
      1.7k
      Views

      alankilianundefined

      @gost101 That will be fine as long as you don't draw too much current for the 5 Volt supply or the connector you are using.

    • Gost101undefined

      Print Problems

      Tuning and tweaking
      • • • Gost101
      11
      0
      Votes
      11
      Posts
      417
      Views

      Phaedruxundefined

      We'd need to see your print settings and config.g to give any more suggestions.

    • Gost101undefined

      Solved Independent Z axis Homing using BL Touch

      Tuning and tweaking
      • • • Gost101
      29
      0
      Votes
      29
      Posts
      1.8k
      Views

      fcwiltundefined

      @Gost101 said in Independent Z axis Homing using BL Touch:

      @fcwilt Thanks for your help. Question though for my z probe offset height is set to 2.250 but Everytime I start a print I have to lower the z axis to -0.15. do I increase the offset hight or decrease it?

      While it may seen odd "higher = closer" - so increase the trigger height it by 0.15 and see how it works.

      Frederick

    • Gost101undefined

      BL Touch

      Tuning and tweaking
      • • • Gost101
      126
      0
      Votes
      126
      Posts
      6.9k
      Views

      fcwiltundefined

      @Phaedrux said in BL Touch:

      We've reached 121 posts in this thread and I think the original issue is no longer present. Do you think you could start a new thread with a restatement of the current problem? Please include all of your config files in one post. That way we can take a fresh look at everything.

      Well that explains why I've had this feeling of answering the same question multiple times.

      Frederick

    • Gost101undefined

      Unsolved CR-10S5 Firmware

      Firmware installation
      • • • Gost101
      145
      0
      Votes
      145
      Posts
      8.2k
      Views

      Gost101undefined

      @bearer I understood what he meant. New comers might not, that's why I mentioned it. Well you all have a wonderful rest of your day.

    • Gost101undefined

      Unable to start up

      Duet Hardware and wiring
      • • • Gost101
      18
      0
      Votes
      18
      Posts
      765
      Views

      Phaedruxundefined

      By default motors won't move until they are homed.

      See here for an example of hardware commissioning steps: https://duet3d.dozuki.com/Guide/Ender+3+Pro+and+Duet+Maestro+Guide+Part+3:+Commissioning/39