Topics created by kmhudgins

; Z-Probe
M558 P9 C"^zprobe.in" H5 F120 T6000 ; set Z probe type to bltouch and the dive height + speeds
M950 S0 C"^zprobe.mod" ; create servo pin 0 for BLTouch
G31 P500 X0 Y0 Z2.5 ; set Z probe trigger value, offset and trigger height
M557 X15:215 Y15:195 S20 ; define mesh grid

this is the code that seems to work.

thank you reformatting the sd card seemed to fix the problem. thank you
for the quick replay. I would have never thought of that possibility.

@kmhudgins said in z=0 inconsistent:

my bed has developed a big dip in the center

Yes I think that's quite common for the creality aluminum beds.

thank you that helped.

@phaedrux yes the psu is a Meanwell power supply. printed off a new frount pannal for the psu giving it more space for air flow and the ability to use a 80 mm fan. However i did not do my research and though there was a standard 3 pin cpu fan header instead of the two pin. I ordered a noctua 80x20 4 pin with the 3 pin converter. Doing some actual research I found i should be able to just plug in the 12v to the positive and the ground to neg. which is how it is set up just was not sure if i could test it or not.

@kmhudgins Well the Hero Me printed successfully, but I managed to choose the wrong part to print. There are over a dozen to choose from. I printed the dual blower mount instead of the single blower mount. 🤦

Yes you can arrange the star gcode to your liking.

As long as there are gcodes in the slicer start code to control the heaters, the slicer will avoid adding it's own. Each slicer has it's own short cut words you can use to insert the temperatures you have defined in the slicer.

Something like M104 S<first_layer_temp>

Each slicer is different and you'll need to do some research to find the values you need.

@veti typo It is set at G29 S1. ill check this this after noon thank you

@phaedrux my esteps were way off i used a profile that some one else set up and it did not seem to work very well for me. so I fallowed the configuration guide the duet has and was able to get much closer to the actual number. with a little more tweaking i have gotten the esteps to a acceptable standard