Topics created by MrBlom

It may be worth adding an item in the DWC wishlist to request support for addons.

Thanks !

Why not utilize the BLTouch for the leveling? Just add in your bed.g file to probe near each lead screw you want to test for, then it will adjust based on that information.

ok thanks for a fast answer
i use s3d

i will try to lower my movement speed and see if that works better

Yes that 10K resistor is fine. Or you can leave it out, but then the firmware won't tell you if you get another VSSA short.

🙂 ok thanks

Found the solution!
i hade tighten the thermistor screw to tight
losen it a bit and it reads normal

Thanks for the info

ok thanks Tony

That is comprehensively solved!