Topics created by TheBiologist

@thebiologist Shouldn't

M92 X160.00 Y160.00 Z8000.00 E873.08

That be Z1600 for 32 microstepping? Not sure I always just use 16 and interpolation.

If you're using the Za and Zb connectors it's a single driver running the motors. If one is going in the wrong direction, flip the connector 180 degrees to change it's rotation.

@TheBiologist

the coordinates for z home are in the homez.g and homeall.g in your sys directory.

@Phaedrux So turned on the printer first thing this morning to try and calibrate the bltouch and went right back to the same issues. I am begining to suspect bad wire in the cable so I have ordered another. Not sure what else it could be. It was working just fine last night. Tested it unmounted, turned it off and mounted it, and then turned it back on this morning.

@TheBiologist said in Smart Effector remaining triggered:

The Light was remaining on and when asked to calibrate the interface reported it as triggered.

When you first power the machine on, does the green LED blink, and if so how many times?