Topics created by verminsup

@dc42 nvm found your reply on another thread from 2022 "...there was an error in the documentation. The thermistor type letter parameter is K not T. I have corrected the documentation." 🙂

@verminsup Yeah!

That Rhinomc.com driver looks perfect for your job although I can't find it on their page, so maybe they don't make it anymore.

It's great you've gotten your machine running again.

@joergs5 Sorry I meant m569. I think I've already tried separate lines but I'll give it another shot

@verminsup First, are you SURE those are BLDC motors?

I see a ribbon cable coming out of the encoder, and a two-wire connector coming out of the back of the motor, so I think they are DC motors with an incremental encoder.

Let's start there and see what you need for a motor-position controller after determining what kind of motor you have.

If you can post:

What Stratasys machine you are trying to convert Links to any documents for that printer Close-up photographs of the motor connections Names, numbers or other markings on the motors you are trying to control

It would help a LOT.

@jay_s_uk
Oh wow that worked, I can't thank you enough.
I was on a tight deadline for getting this to work.

@jay_s_uk sorry about that had a brain fart moment, I understand now I got confused because the link you provided says those drivers are supported but that's for the LPC boards I assumed it meant RRF in general has support for those and since Duet is running RRF I assumed it could drive them but I get it wasn't designed to support them via hardware well it does but I'd lose a lot of functionality. I get it now it's the same thing with those marlin boards some support the UART, or SPI but never both interfaces because the pins are not broken out, etc. Thanks for all your help Jay, I'm barely learning RRF and getting into the Duet ecosystem.