Topics created by Vladimir_U

@Vladimir_U as the kinematics is linear and the extruders operate independently of the axis motors, it is supported by RRF. Use the M669 command to define the correct movement matrix for it.

@dc42 Yes, I know about it. But I didn't have these arduino models in stock. It was interesting to connect the "nano" that I had. And everything worked out...

@vladimir_u said in Future development?:

@infiniteloop Unfortunately, socialism has lost to capitalism...probably with our help.

Large scale socialism is doomed to get corrupt and fail.

Small scale socialism is the norm for thousands of years. Every household is a socialist unit, "From each according to ability; to each according to need".

Have a look here as well

https://duet3d.dozuki.com/Wiki/GCode_Meta_Commands

Using the object model to get the state of the printer and conditional gcode to check it on a regular interval in the daemon.g file would probably get you what you want.

@dc42 My printer uses a hotend other than e3dv6. the thermistor there is located closer to the heater. Perhaps for this reason he is more sensitive. However. As a result of several experiments, with the implementation of the M303 with different blowing power, I stopped at the option when calibration occurs with a blowout of 35 percent. Fluctuations when switching within 3 degrees. The best with this configuration can not be achieved, I think.
photo_2022-01-20_21-02-14.jpg photo_2022-01-20_20-51-09.jpg

@phaedrux No, nothing bad is happening

@phaedrux Thank you very much.

the problem turned out to be the steppers themselves. they looked identical, but the noise from them was great. replacing the steppers solved my problem.

@vladimir_u I've added Cyrillic support on the 12864 to the work list.