Posts made by wbrokow1

@droftarts OK thanks

The D7 and D9 LED on the effector were destroyed by mechanical means.
DO I need to replace these or will the effector function fully without them.
Revision 4.0 Smart effector.

Thanks for any help

@oliof is there an advantage to use rrf on the smoothie board?

I would buy an updated effector and new extruder assembly if available.

@oliof I am running smoothieware

I have a delta kossel with a smoothieboard currently setup. I purchased the effector 4.0 .
Anyone have experience setting this style printer up?

What is the proper M code to turn off the bed heater when a print is finished?
Voron 2.4 with Duet3 6hc mainboard

Thanks
Walter

@R4ffers config (1).g

@Phaedrux I am at 12000mm/min

Hi , I think I have my speed settings too low on my voron 2.4 .

I use a duet 3 6hc and 3hc. If you could post your config.g files it would be Great.
Thx

@wbrokow1 Ok. I figured it out. I downloaded the dwc.zip file and extracted into the www directory and it seems to be fully functional
Thanks

@wbrokow1 It seems I have to put dwc on the /www directory.
How ?

@wbrokow1 I accidentally deleted dwc-setting.json file

What can I do?

@HebigT ok read the link. But want to be sure:

So I can format a new sd card in a PC according to the instructions?

Take the sd from the duet3 mb and create a directory on my PC and copy all the files as a backup?

Copy all files from backup directory to newly formatted sd card and then insert back into duet3d mb and I am ready to go?

just want to be sure because I dont want to screw up my setup!

Thanks,
Walter

@wbrokow1 m39 says 0.18gb left out of 16gb. I tried deleting files though DWC but I don't think it's really clearing up space. how do I do It manually?

I would like to try a new sd card due to file uploading error.
Exactly how do I do it and what files need to be on the card?
Thanks

@tas Ah, ok . thanks for the help! this should be written somewhere. It probably is, I just didn't look hard enough.
To everyone who participated: thank you very much

@tas ok thanks. it worked!
So now if I record a profile can I use it each time I print something?
I don't have to record a new one every time I print something, right?
Thanks again for your help

@dc42 how do I change the sample rate?

@dc42 ok I will give it a try

thanks